this is just a home system. i am doing as an experiment kind of, just to see if i can make it work. i was running it off a cheap GM stereo, 10 watts per channel, and was using the left and right from the stereo to power the sub, and then using the subs two outputs to run some teac 2 way's. and, i was using the left channel of the stereo AS WELL to power a MTX 150 watt car sub. a bit risky, but it was working fine. i was getting pissed off with the mega distortion at high volume, so i got this amp off my uncle (Realistic MPA-80) to try and thump it a bit louder
how do you run the output from the amp, which is mono, into the sub, which requires two channels?? do you split the wires to run into both terminals? eg. split the positive wire running from the amp into two and clip one into the left positive and one into the right positive?