Upgraded to Audio Note J - and other musings.

[92135011]

Kit 2 is a power amp, but it has a volume pot so that if you have a source with a high enough output you can run it without a pre. The kit2 is built based on the Kit1 except that its the non-triode version running on 6550 pentode. The kit1 runs $1349 and is 300B SET, no feedback, directly heated running about 9 WPC. The upgrades entitle a "high-B" OPT, black gate caps, copper film oil caps, tantalum resistors, silver wiring, better pot). The preamp kit runs $699, as upgrades like the above, and as I said, a new chassis coming soon.
BTW, they are coming out with some 211 monos soon, probably for the extra power or something. Also, a new integrated is in production. However, this will be a budget push-pull integrated probably much like the soro pp. Hence, even after these new products, the kit1 will remain their most popular amp. As you can see, I have asked Brian many many questions.
In regard to the equipment needed, I think a soldering pen, solder, stripper, cutter and pliers is enough to get the job done. I think they include everything else. Plastic wire ties may be worth the extra 50 cents too as it will make everything nice and tidy. Just the soldering pen and solder would do...but then the result would look very messy amateur. Actually, I'm going to buy a new stripper just for this project as my old one is dull and no longer does the job well.

[RGA]

Kit 2 is a power amp, but it has a volume pot so that if you have a source with a high enough output you can run it without a pre. The kit2 is built based on the Kit1 except that its the non-triode version running on 6550 pentode. The kit1 runs $1349 and is 300B SET, no feedback, directly heated running about 9 WPC. The upgrades entitle a "high-B" OPT, black gate caps, copper film oil caps, tantalum resistors, silver wiring, better pot). The preamp kit runs $699, as upgrades like the above, and as I said, a new chassis coming soon.
BTW, they are coming out with some 211 monos soon, probably for the extra power or something. Also, a new integrated is in production. However, this will be a budget push-pull integrated probably much like the soro pp. Hence, even after these new products, the kit1 will remain their most popular amp. As you can see, I have asked Brian many many questions.
In regard to the equipment needed, I think a soldering pen, solder, stripper, cutter and pliers is enough to get the job done. I think they include everything else. Plastic wire ties may be worth the extra 50 cents too as it will make everything nice and tidy. Just the soldering pen and solder would do...but then the result would look very messy amateur. Actually, I'm going to buy a new stripper just for this project as my old one is dull and no longer does the job well.

Well when the time comes I will go and listen to the ones built by the guys at soundhounds. this way I will actually get to hear the kit before I buy. If i like it I will build one.

[92135011]

Well when the time comes I will go and listen to the ones built by the guys at soundhounds. this way I will actually get to hear the kit before I buy. If i like it I will build one.

Soundhounds has the kit1 but they dont have the preamp. If you drop by vancouver, you can give it a try at my place if you wish. I havent built it yet, but will in due time.