Anyone using Mackie or Corwn amps?

[jbangelfish]

They do take up some space and they are fairly heavy but don't let that bother you. A lot of good amps are big and heavy. This would be a great amp for a sub. There are a couple of series II DC300A's coming up on ebay and are just later models. Should have the same build quality but are dark grey or black and have a switch for bridging mono. They usually run a little higher in price than the silver or older models but I would not be afraid of any of them. By all means, let us know what you get and how you like it.
Bill

[grampi]

I'll keep you posted. Thanks.

[grampi]

How do you connect the line level outputs from your receiver to the inputs on the DC300? It doesn't accept RCA connectors?

[jbangelfish]

It uses 1/4 inch jacks like PA equipment. They come from the factory with IC's that are made this way with normal RCA's on one end and the 1/4 inch on the other. I would think someone has them but you could make your own.
Bill

[thepogue]

http://cgi.ebay.com/ws/eBayISAPI.dll...category=39783

http://cgi.ebay.com/ws/eBayISAPI.dll...tem=3072853264

http://cgi.ebay.com/ws/eBayISAPI.dll...category=39783

http://cgi.ebay.com/ws/eBayISAPI.dll...category=39783

http://cgi.ebay.com/ws/eBayISAPI.dll...category=39783

http://cgi.ebay.com/ws/eBayISAPI.dll...category=39783

http://cgi.ebay.com/ws/eBayISAPI.dll...category=39783

http://cgi.ebay.com/ws/eBayISAPI.dll...category=39783

http://cgi.ebay.com/ws/eBayISAPI.dll...category=39783

there are tons out there....just hunt'em down...and remember to look @ the spec's for a bridged application and BTW Carver made some Great amps and some junk in the mid 80's to eairly 90's.

[grampi]

That's a pretty impressive list of amps there. Does anyone know if the Phase Linear 400 is bridgeable into 4 ohms, and if so, what is its power rating is in this configuration? Thanks.

[grampi]

The Adcom GFA 555 looks like a decent sub amp as well. Anybody know what its 4 ohm bridged mono power rating is?