Results 1 to 13 of 13
Like Tree1Likes
  • 1 Post By Feanor

Thread: Bridging NADs

  1. #1
    Forum Regular
    Join Date
    Aug 2016
    Posts
    5

    Bridging NADs

    Hello all. My first post, so bear with me. I will very soon take possession of two NAD 214 Amplifiers. They will join a NAD 7155 Integrated Amp and a NAD C541i CD Player. I am currently driving either JBL Studio 230s or KEF Q Compacts as well as a Definitive Technologies 200TL powered sub.

    My question is can I bridge the 214s and use the 7155 as a preamp? And, if so, how do I go about wiring it up. The NAD manuals aren't the clearest things in the world when it comes to bridging anyway. I keep looking for a diagram (a picture is worth a ....) but cannot find one specific for my needs.

    I noticed several postings on this site about bridging NADs with Maggies(?) but they didn't seem to apply to my situation. Any help is appreciated!

  2. #2
    Shostakovich fan Feanor's Avatar
    Join Date
    Jun 2002
    Location
    London, Ontario
    Posts
    8,127
    Quote Originally Posted by Dogsnif View Post
    Hello all. My first post, so bear with me. I will very soon take possession of two NAD 214 Amplifiers. They will join a NAD 7155 Integrated Amp and a NAD C541i CD Player. I am currently driving either JBL Studio 230s or KEF Q Compacts as well as a Definitive Technologies 200TL powered sub.

    My question is can I bridge the 214s and use the 7155 as a preamp? And, if so, how do I go about wiring it up. The NAD manuals aren't the clearest things in the world when it comes to bridging anyway. I keep looking for a diagram (a picture is worth a ....) but cannot find one specific for my needs.

    I noticed several postings on this site about bridging NADs with Maggies(?) but they didn't seem to apply to my situation. Any help is appreciated!
    Bridging the 214 is a simple matter but beware that bridging should only be used (in case of the 214) with speakers whose impedance is 8 ohms or higher. I see that both the JBLs and the KEFs are 8 ohms, so no problem;

    Here is a picture of the rear of the 214. With the amp off and the speakers disconnected, first move the 'Bridge Mode' switch from 'Off/Stereo' to 'On/Mono', then connect the both speaker cable connectors from a single speaker to the RED speaker output connectors, i.e. cable end '+' to the indicated '+' Red speaker output, and '-' to the '-' Red output as indicated on the amp.

    Bridging NADs-908163-nad-214-power-amplifier.jpg

  3. #3
    Forum Regular
    Join Date
    Aug 2016
    Posts
    5
    Thanks so much for responding Feanor! I'm assuming that the Left RCA output coming from the Pre-out on the 7155 would go to the Left input on 214-A and the Right RCA output would go to the Left input on 214-B per the attached crude diagram. Bridging NADs-nad-bridged-system-layout.jpg
    Last edited by Dogsnif; 08-23-2016 at 06:47 PM. Reason: Had pre-out RCAs backwards

  4. #4
    Shostakovich fan Feanor's Avatar
    Join Date
    Jun 2002
    Location
    London, Ontario
    Posts
    8,127
    Quote Originally Posted by Dogsnif View Post
    Thanks so much for responding Feanor! I'm assuming that the Left RCA output coming from the Pre-out on the 7155 would go to the Left input on 214-A and the Right RCA output would go to the Left input on 214-B per the attached crude diagram. Click image for larger version. 

Name:	NAD Bridged System Layout.jpg 
Views:	2816 
Size:	29.4 KB 
ID:	9995
    Yes, that's right. Per the instruction on the rear of the amps themselves, the both the Left and Right outputs on the amps go the Left (Mono) input on the respective amps.

  5. #5
    Forum Regular
    Join Date
    Aug 2016
    Posts
    5
    Quote Originally Posted by Feanor View Post
    Yes, that's right. Per the instruction on the rear of the amps themselves, the both the Left and Right outputs on the amps go the Left (Mono) input on the respective amps.
    Thanks again. I noticed that your system configuration shows that you run your subwoofer off of your preamp but I don't know if your preamp has a dedicated sub channel. I'm wondering if I can do the same by running my sub off of the NAD 7155 that does not have a separate sub channel.

  6. #6
    Shostakovich fan Feanor's Avatar
    Join Date
    Jun 2002
    Location
    London, Ontario
    Posts
    8,127
    Quote Originally Posted by Dogsnif View Post
    Thanks again. I noticed that your system configuration shows that you run your subwoofer off of your preamp but I don't know if your preamp has a dedicated sub channel. I'm wondering if I can do the same by running my sub off of the NAD 7155 that does not have a separate sub channel.
    Yes, you can provided your sub has stereo, (i.e. both Left & Right), RCA input connectors as most do, (and not just one, 'LFE' input). You will run interconnect cables from the Preamp output on the 7155 to you sub, BUT since the 7155 has only one set of Preamp outs, you will need a 'Y' connector to divide the outgoing signal between you power amps and the sub.

    Here is a type of RCA 'Y' adaptor: you need a Left and a Right; each has one male input plug, (goes to the 7155 Preamp out), and two female output, (attach one interconnect for the power amp and one for the sub) ...



    This is another design of 'Y' adaptor that does the same thing ...


  7. #7
    Forum Regular
    Join Date
    Aug 2016
    Posts
    5
    Thanks for your patience. I was wondering why I couldn't just use the unused 7155 speaker connections straight to the sub but I figured that's what the manual was talking about when it says that the Pre-out controls the front panel and the Main-in controls the speakers. Duh! I guess what lead me to the thought of using the unused speaker terminals is that when I use my tube amp (Yaqin MC-13s) I use banana plugs for the main speakers and then double up with spade connecters to send juice to the sub. I've got to stop thinking so much!

  8. #8
    Shostakovich fan Feanor's Avatar
    Join Date
    Jun 2002
    Location
    London, Ontario
    Posts
    8,127
    The Main-Ins supplies signal to the 7155's built-in power amp; if you disconnect them from the Pre-Outs no signal goes the the 7155's power amps so there will be no signal coming from its speaker connections.

    Of course you could use a 'Y' connector to feed both the external power amps and the 7155's Main-In, but it would be better, (if using a 'Y' connector), to directly feed the sub's Line-level RCA inputs.

  9. #9
    Shostakovich fan Feanor's Avatar
    Join Date
    Jun 2002
    Location
    London, Ontario
    Posts
    8,127
    Quote Originally Posted by Dogsnif View Post
    Thanks for your patience. I was wondering why I couldn't just use the unused 7155 speaker connections straight to the sub but I figured that's what the manual was talking about when it says that the Pre-out controls the front panel and the Main-in controls the speakers. Duh! I guess what lead me to the thought of using the unused speaker terminals is that when I use my tube amp (Yaqin MC-13s) I use banana plugs for the main speakers and then double up with spade connecters to send juice to the sub. I've got to stop thinking so much!
    If you have interconnects from your 7155's Preamp Out connectors to your external power amps, then the 7155's internal power amps aren't getting a signal and, accordingly, the Speaker outputs can't pass a long a signal to your sub.

  10. #10
    Suspended
    Join Date
    Oct 2005
    Posts
    928
    How disappointing. From the title I thought this was another sex ad:-)

  11. #11
    Forum Regular
    Join Date
    Aug 2016
    Posts
    5
    Quote Originally Posted by bfalls View Post
    How disappointing. From the title I thought this was another sex ad:-)
    Too funny!

  12. #12
    Forum Regular
    Join Date
    Sep 2016
    Posts
    7
    I bridged a pair of 3020's early in my audiophile experimenting, but never got good sound.

  13. #13
    Forum Regular blackraven's Avatar
    Join Date
    Nov 2006
    Location
    St. Paul, Minnesota
    Posts
    5,421
    is any one having trouble posting? AR has been wonky this week
    Pass Labs X250 amp, BAT Vk-51se Preamp,
    Thorens TD-145 TT, Bellari phono preamp, Nagaoka MP-200 Cartridge
    Magnepan QR1.6 speakers
    Luxman DA-06 DAC
    Van Alstine Ultra Plus Hybrid Tube DAC
    Dual Martin Logan Original Dynamo Subs
    Parasound A21 amp
    Vintage Luxman T-110 tuner
    Magnepan MMG's, Grant Fidelity DAC-11, Class D CDA254 amp
    Monitor Audio S1 speakers, PSB B6 speakers
    Vintage Technic's Integrated amp
    Music Hall 25.2 CDP
    Adcom GFR 700 AVR
    Cables- Cardas, Silnote, BJC
    Velodyne CHT 8 sub

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •