Hello everyone,

I just purchased a pair of Kimber 8TC speaker cables off Audiogon. Each end terminates in factory supplied banana plugs.

Unfortunately, the binding posts on the back of my amp - a NAD C320BEE - only accept spades and/or bare wire. So my question is: what's the easiest way to covert one end to spades? Typically I would strip the wire myself, but 8TC strands are so thin, and there are so many, I'm afraid that will be too difficult.

Should I buy some sort of tool? Do I have to take them in? Suggestions please, thanks!

Best,
Clay