jrhymeammo
07-17-2010, 05:58 PM
Audio Zone Pre-T1 Preamp.
7158
This passive preamp is based on TX102 transformers.
A brief comparison to the Sonic Euphoria PLC
1. High freq - Pre-T1 sparkles with less grain.
2. Mid freq - PLC has a bit more body, but Pre-T1 is more transparent with better balance.
3. Low freq - PLC has more emphasis on bass but a bit bloated at times.
4. Volume Control - PLC has finer volume settings, but the Pre-T1 has +6dB switch.
5. Connectibility - PLC has 4(inputs)/2(outputs) pairs with Tape Out. Pre-T1 is
factory set to 3/1 or 2/2 option.
My unit came with 2/2, but I have the Burson AB160, so that makes it 3/2.
The Manley Skipjack or other switchers may be required for some. PLC came with 1 pair of WTB RCA for both In/Output. Pre-T1 is equipped with regular generic RCA connectors.
The WTB connectors sound cool, but I think the cost difference should be allocated to other part of audio where it actually makes obvious difference. But the WBT connectors seem to make better physical connection to all interconnects.
6. Ground - Pre-T1 has Ground Float with a switch, PLC comes with a ground wire.
Pre-T1's ground float works, while PLC didn't make a difference in MY environment, but was never an issue. Pre-T1's ground float is only noticable when turned all the way up so it should not be beneficial during normal playback.
7. Design Base - PLC is Autoformer wound and entirely wired with Cardas. Pre-T1 is S&B TX102 ver.1 transformers based.
8 Problem - I now have 3 preamps, and have to decide which one to sell...
Have Fun,
JRA
7158
This passive preamp is based on TX102 transformers.
A brief comparison to the Sonic Euphoria PLC
1. High freq - Pre-T1 sparkles with less grain.
2. Mid freq - PLC has a bit more body, but Pre-T1 is more transparent with better balance.
3. Low freq - PLC has more emphasis on bass but a bit bloated at times.
4. Volume Control - PLC has finer volume settings, but the Pre-T1 has +6dB switch.
5. Connectibility - PLC has 4(inputs)/2(outputs) pairs with Tape Out. Pre-T1 is
factory set to 3/1 or 2/2 option.
My unit came with 2/2, but I have the Burson AB160, so that makes it 3/2.
The Manley Skipjack or other switchers may be required for some. PLC came with 1 pair of WTB RCA for both In/Output. Pre-T1 is equipped with regular generic RCA connectors.
The WTB connectors sound cool, but I think the cost difference should be allocated to other part of audio where it actually makes obvious difference. But the WBT connectors seem to make better physical connection to all interconnects.
6. Ground - Pre-T1 has Ground Float with a switch, PLC comes with a ground wire.
Pre-T1's ground float works, while PLC didn't make a difference in MY environment, but was never an issue. Pre-T1's ground float is only noticable when turned all the way up so it should not be beneficial during normal playback.
7. Design Base - PLC is Autoformer wound and entirely wired with Cardas. Pre-T1 is S&B TX102 ver.1 transformers based.
8 Problem - I now have 3 preamps, and have to decide which one to sell...
Have Fun,
JRA