Nagaoka MP 110 vs. Ortofon 2M RED [Archive] - Audio & Video Forums

PDA

View Full Version : Nagaoka MP 110 vs. Ortofon 2M RED



Enochrome
02-26-2010, 05:55 PM
Anyone have any consensus between the two?

Does anyone know if the Nagaoka MP 110 is a high compliance cartridge ( that particular spec seems to be missing in the literature)?

Any particular perspectives or philosophy on their compatibility with a low-mass tonearm?

Gracias!

JohnMichael
02-26-2010, 06:40 PM
Nagaoka MP-110 MP110
Phono Cartridge Specifications

Type
Moving Magnet

Cantilever
Aluminum Alloy

Stylus type
SuperFine polished elliptical, bonded diamond

Stylus tip radius 0.4 x 0.7 mil
Weight 6.5 grams
Output voltage
5mV (5cm/sec)

Frequency characteristic 20 - 20,000 Hz
Channel balance Better than 1.5 dB
Channel separation
Better than 23 dB at 1 kHz

Recommended loading
47,000 ohms

Dynamic Compliance
6.0 x 10-6 cm/dyne

Static Compliance
18 x 10-6 cm/dyne

Tracking force range
1.5 - 2.0 g

Break-in period
30 hours

Replacement stylus
Nagaoka JN-P110

JohnMichael
02-26-2010, 06:44 PM
Ortofon 2M Red Phono Cartridge Specifications:


•Output voltage at 1000 Hz, 5cm/sec.: 5.5 mV

•Channel balance at 1 kHz: 1.5 dB

•Channel separation at 1 kHz: 22 dB

•Channel separation at 15 kHz: 15 dB

•Frequency range at - 3dB: 20-22.000 Hz

•Frequency response: 20-20.000 Hz + 3 / - 1 dB

•Tracking ability at 315Hz at recommended tracking force: 70 µm

•Compliance, dynamic, lateral: 20 µm/mN

•Stylus type: Elliptical

•Stylus tip radius: r/R 8/18 µm

•Tracking force range: 1,6-2,0g (16-20 mN)

•Tracking force, recommended: 1.8 g (18 mN)

•Tracking angle: 20°

•Internal impedance, DC resistance: 1.3 kOhm

•Internal inductance: 700 mH

•Recommended load resistance: 47 kOhm

•Recommended load capacitance: 150-300 pF

•Cartridge weight: 7.2g



Hopefully someone will be able to compare the compliance ratings since they use dfifferent methods of reporting.

jrhymeammo
02-26-2010, 07:05 PM
I've posted a wrong reply.

Check out this link.
http://www.tnt-audio.com/sorgenti/nagaoka_mp11_e.html

Enochrome
02-26-2010, 07:07 PM
JohnMichael,

Thanks for those specs!! I could not find the dynamic compliance specs for the Nagaoka before, for some reason? It seems that the 2M red is high compliant and the reviews have been, for the most part, stellar. I read an article on how to translate the Nagoaka compliancy specs, but I'll have to dig up that article. I am really interested in that warm sound of the Nagaoka.

Thanks again. Have you heard either, or something similar?

Cheers - Enochrome

Enochrome
02-26-2010, 07:08 PM
I have a Luxman PD-272 that has a Luxman low-ass arm, that I believe was made by Micro-Seiki.

Enochrome
02-26-2010, 07:09 PM
So, if the Nagaoka is low compliant it probably won't be a suitable fit?

Enochrome
02-26-2010, 07:10 PM
Hahahaaahaha!!! Excuse me, I meant "low-mass", not "low-ass"! Ha, vinyl humor ;)

02audionoob
02-26-2010, 07:16 PM
Ideally, you need a high-compliance stylus on a low-mass arm. However, there are few truly high-compliance cartridges. Your best bet when aiming for that characteristic is likely the Ortofon OM20. These styli that can use a tracking force of as much as 2.0 grams are not ordinarily high compliance, even if you don't see matching reporting techniques to bear that out.

That particular characteristic isn't the final word on suitable cartridges, though. A Grado might get you what you're looking for...or a Shure M97XE.

http://www.lpgear.com/Merchant2/merchant.mvc?Screen=PROD&Store_Code=LG&Product_Code=GRADBLUSTD

http://www.lpgear.com/Merchant2/merchant.mvc?Screen=PROD&Store_Code=LG&Product_Code=SHEC03&Category_Code=S15

JohnMichael
02-26-2010, 07:39 PM
JohnMichael,

Thanks for those specs!! I could not find the dynamic compliance specs for the Nagaoka before, for some reason? It seems that the 2M red is high compliant and the reviews have been, for the most part, stellar. I read an article on how to translate the Nagoaka compliancy specs, but I'll have to dig up that article. I am really interested in that warm sound of the Nagaoka.

Thanks again. Have you heard either, or something similar?

Cheers - Enochrome


Enochrome,

Back in the days and I mean the late 70's and very early 80's a local audio store carried the Nagaoka cartridges. I purchased one and liked the sound. I used it in a fairly heavy S shaped tonearm on a Kenwood ttable. I owned it too long ago to comment on the sound. I do remeber it was a good match for a higher mass arm. The Ortofon and I currently own an OM20 cartridge is a good match for the Rega arm and lower mass arms.

JM

JohnMichael
02-26-2010, 07:42 PM
That particular characteristic isn't the final word on suitable cartridges, though. A Grado might get you what you're looking for...





02audionoob is right in that the Grado may give you the warmth you are looking for.

Enochrome
02-26-2010, 07:47 PM
Thanks 02audionoob! Your post are always helpful and have focused my search. So, i think i'll wait on the Nagaoka for a different table. As far as the Ortofon's, the 2M Red rated compliancy is 20, isn't that considered high? I remember your post of OM10 as well, which is essentially the reason why I was able to widdle down my options.

Is there much of difference between the OM10 and the 2M Red? The 2M has seemed to be getting all the rave reviews.

Thanks for your advice and recommendations.

Enochrome
02-26-2010, 07:53 PM
JohnMichael ,
I am very impressed with Grado as an all around quality company. I love
the Grado headphones that I have had over the years. The Prestige Blue looks inviting. I have not mentioned them, because I thought I would discover other audio brands as to further my experience, but only for that reason. Bar none, Grado does have my loyalty for sure, in fact they started me on my quest for quality sound.

Cheers!

Enochrome
02-26-2010, 07:56 PM
By the way, do you guys know a good way to polish the platter of a turntable. I kind of want that mirror shine. I know it's superficial, but hey, it's a mans gear, what are you gonna do!

dean_martin
02-26-2010, 08:13 PM
I have the 2M Red on a Technics 1200 with the heavy s-shaped stock arm. I use the add- on end piece for extra weight and a Sumiko headshell that is heavier than tstock. The 2M Red seems to like the added weight. My guess is that Ortofon's OM20 would be a better match with a "low-ass" arm. The Ortofon OM series cart comes with many of Pro-Ject's tables in Europe. Pro-Ject's arms are low to medium mass. Compliance is something I've yet to get my head around. I see the numbers but don't know what they mean. I have to draw inferences here and there

I would love to listen to a Nagaoka cart.

poppachubby
02-26-2010, 09:06 PM
The Nagaoka is a smooth and warm cart also. I have heard it, but have not owned it. It could very well rival the lower end Grados.

I have a 2M Red and an OMB-10, both are fine sounding carts with very forward sound. I love them. I was simply amazed at what the OMB-10 was capable of once it broke in. I quite literally got excited about listening to it, and found myself in a HUGE vinyl cave. My wife was none too pleased as every waking moment was spent listening to it.

I recently put a Shure M97xe on one of my tables, courtesy of 02audionoob. It took me a short while to get used to it. Indeed quite laid back but once your ears adjust, it's quite an amazing sound. Excellent for long sessions as there is no fatigue whatsoever. It somehow manages to stay engaging despite it's mellow ways, this is through the detail it provides.

I would say if you like an "in your face" sound, with alot of presence, go for the Ortofon. This is the type of sound I prefer. If you want something a tad more tame, try the Nagaoka. Either way you can't lose.

02audionoob
02-26-2010, 09:48 PM
Thanks 02audionoob! Your post are always helpful and have focused my search. So, i think i'll wait on the Nagaoka for a different table. As far as the Ortofon's, the 2M Red rated compliancy is 20, isn't that considered high? I remember your post of OM10 as well, which is essentially the reason why I was able to widdle down my options.

Is there much of difference between the OM10 and the 2M Red? The 2M has seemed to be getting all the rave reviews.

Thanks for your advice and recommendations.

But look at the compliance spec for the OM20...it's 25. And you're quite welcome. It's always great fun to help out in the analog room.

Ooh, ooh...one more thing. The reason you might not see reviews of the OM10 is that it's outgoing...dead...toast...outta here. The OM series was replaced by the 2M series.

poppachubby
02-26-2010, 10:09 PM
Indeed, and here's the result...http://www.turntableneedles.com/Ortofon-OMB-10_p_2999.html

You asked about $100? Get your cart and have enough left over to buy some vinyl too!

02audionoob
02-26-2010, 10:14 PM
I think the compliance number listed for the OMB-10 at turntableneedles.com is incorrect, but I can't find the offical Ortofon chart at the moment to verify that.

Edit...nope, found it. According to the Ortofon website it's correct at 25.