Help connecting rear back surround speakers

[gcook67]

I have a Kenwood VR-8050 home theatre receiver and just purchased two surround back speakers, however on the back of my receiver I only have one terminal to connect my surround back speakers to. Does anybody know how I would properly wire up both back speakers using only one speaker terminal on the back of my receiver?
The other thing I am concerned about is that all my other home theatre speakers are an 8ohm, but the new speakers i just got are 6ohm.

[PAT.P]

I have a Kenwood VR-8050 home theatre receiver and just purchased two surround back speakers, however on the back of my receiver I only have one terminal to connect my surround back speakers to. Does anybody know how I would properly wire up both back speakers using only one speaker terminal on the back of my receiver?
The other thing I am concerned about is that all my other home theatre speakers are an 8ohm, but the new speakers i just got are 6ohm.This receiver is probably a 6.1,and only 1 speaker should be install for the back surround speaker.Either a bookshelf or a center.The only thing to do is to buy another receiver 7.1 or put speakers in series will give you 12 0hm.I added a pic (car audio) but would be the same using a receiver.

[gcook67]

Thanks so much for helping me out. I will wire them according to your diagram and then eventually will purchase a new 7.1 receiver. Thanks once again for your help!! :)

[shokhead]

I belive you have a single rear center out,thats what you may be looking at,there should be 2 seperate outputs for SL and SR. Look again.